Tilta Nucleus-M Wireless Follow Focus
Standard kit includes:
Wireless FIZ Controller
3 Motors
2 Handles for Focus and Iris/Zoom
7 pin Motor and D-Tap Power cables
Daily rate: £100 +VAT
Standard kit includes:
Wireless FIZ Controller
3 Motors
2 Handles for Focus and Iris/Zoom
7 pin Motor and D-Tap Power cables
Daily rate: £100 +VAT
Standard kit includes:
Wireless FIZ Controller
3 Motors
2 Handles for Focus and Iris/Zoom
7 pin Motor and D-Tap Power cables
Daily rate: £100 +VAT
-
This is a great piece of kit. It has a good range and is very reliable. The motor is very powerful, capable of pulling the heaviest of lenses and yet extremely quiet.
-
TILTA NUCLEUS-M WIRELESS FOLLOW FOCUS SYSTEM
1. The Nucleus-M is a wireless 3 Channel system.
2. Connections between the FIZ hand unit and the two hand grips to the motors are completely wireless.
3. Each motor has a built-in MDR unit, saving space and setup time.
4. A single motor can be powered directly from the camera’s battery though a 7-Pin to P-TAP cable then daisy chained via 7-Pin to 7-Pin cable to run additional motors.
5. There is no limit on the amount of motors an operator can attach per channel.
6. The FIZ hand unit and two handle grips have a wireless range of 1000 feet.
7. The signal from the FIZ hand unit can be upgraded to 1 1/4 miles with an additional accessory.
8. Both hand grips and FIZ hand unit run off (2) 18650 batteries. (Batteries are NOT included.)
9. When fully charged the batteries in the hand grips can last up to 2 days.
10. The batteries in the FIZ unit can last up to 10 hours.
11. FIZ hand unit is capable of controlling 3 channels – focus, zoom, and iris as well as overriding the hand grips.
12. 0.8 mod, 35-tooth, 32 pitch gear with a face width of 10mm
13. Motors can calibrate on lenses without hard stops – such as photo-lens with follow focus gears.
14. Motors fit standard 15mm and 19mm Rods
15. Ideal for Gimbal, Drone, and Shoulder-mounted setups
-
Color:
Gunmetal Grey
Material:
Aluminum-Alloy
Stainless Steel
ABS Plastic
Rubber
Brazilian Rosewood
Weight:
FIZ Hand Unit (with focus disk but no batteries): 0.972 lb
FIZ Hand Unit (with focus disk and batteries): 1.164 lb
Right Handle Grip (no batteries or adapters): 0.582 lb
Left Handle Grip (no batteries or adapters): 0.529 lb
Arri Rosette Male to Handle Grip Adapter: 0.161 lb
25mm/30mm Gimbal to Handle Grip Adapter: 0.099 lb
Motor (no rail adapter): 0.419 lb
Motor with 15mm rail adapter: 0.496 lb
Motor with 19mm rail adapter: 0.487 lb
Motor Dimensions:
Length/Height: 4 1/2 Inches
Width: 2 3/4 Inches (motor plus rail adapter)
Width: 2 5/8 Inches (ports to tip of gear)
Width: 3 2/8 Inches (end to end furthest points)
Depth: 5/8 Inches (rail mount section)
Depth: 3/4 Inch (base section)
Depth: 1 3/8 Inches (motor section)
